ATSC 3.0 Channels Missing?

ATSC 3.0 Nextgen TV Forum
Post Reply
AZ Jaybird
Posts: 2
Joined: Thu Feb 29, 2024 8:58 pm

ATSC 3.0 Channels Missing?

Post by AZ Jaybird »

While there have been six ATSC 3.0 channels shown in my HDHomeRun detected channel list for months, they are no longer showing up when I rescanned my Flex 4K this morning after installing EAS Capture app? I’m in Northern AZ and looking at Cottonwood repeaters. My Flex is running the Nov 7th version of firmware. Are others experiencing a similar issue, or is this market specific in advance of today’s National EAS test?

jasonl
Silicondust
Posts: 17989
Joined: Sun Oct 28, 2007 9:23 pm
x 123

Re: ATSC 3.0 Channels Missing?

Post by jasonl »

I don't believe there have ever been ATSC 3.0 broadcasts anywhere in Northern AZ. Scripps has 2 translators on Mingus Mountain, one that has always been KNXV and one that used to be KASW but switched to a duplicate of KNXV when KASW started broadcasting in 3.0. It is possible that tropospheric ducting might have brought enough signal in from Phoenix to be able to scan the channels; it's a lot more likely with 3.0 since the low-level signalling data is transmitted in a way that can be received with a much worse signal than the audio and video data.

AZ Jaybird
Posts: 2
Joined: Thu Feb 29, 2024 8:58 pm

Re: ATSC 3.0 Channels Missing?

Post by AZ Jaybird »

Thanks for the reply. Although the Flex re-detected the ATSC 3.0 programs after the EAS test completed today, your suggestion explains the situation.

The channel 27 RF signal from Phoenix lists the ATSC3.0 programs detected by the Flex. With the transmitter’s 445KW ERP Ch 27’s contour (according to Signal GH) extends to ~10 miles south of us. Since attempting to tune the ATSC 3.0 programs always result in the same content protection error message, it’s probably not a concern until they add 3.0 transmissions up here.

Online
signcarver
Expert
Posts: 11567
Joined: Wed Jan 24, 2007 1:04 am
Device ID: 10A05954 10802091 131B34B7 13231F92 1070A18E 1073ED6F 15300C36
x 30

Re: ATSC 3.0 Channels Missing?

Post by signcarver »

You may be experiencing the difference in the new firmware as the old firmware used to pick up the channel info available from plp0 which can punch through quite well but the video was on plp1 which most likely would have been unviewable. See viewtopic.php?t=80860

Post Reply