20261107 firmware channel scan may report lower signal quality than before (ATSC 3.0 channels only)

ATSC 3.0 Nextgen TV Forum
Post Reply
nickk
Silicondust
Posts: 21249
Joined: Tue Jan 13, 2004 9:39 am
x 455

20261107 firmware channel scan may report lower signal quality than before (ATSC 3.0 channels only)

Post by nickk »

20261107 firmware channel scan may report lower signal quality than before (ATSC 3.0 channels only).

* Reception performance has not changed.
* The signal quality % scaling has not changed.
* The reported signal quality % when watching a virtual channel hasn't changed.

What is happening:

ATSC 3.0 supports Physical Layer Pipes (PLPs) where on physical channel can carry multiple modulations, each with its own reception profile (how easy or hard it is to receive).

It is common for stations to broadcast the virtual channel information on a low bitrate PLP that is easy to receive, and then broadcast the audio/video data on a separate PLP with a normal high bitrate reception profile. For the virtual channel to work both PLPs must be received.

The signal quality % is scaled value such that 50% is the minimum signal-to-noise the modulation is rated for. This point is different for each PLP and when multiple PLPs are required the HDHomeRun reports the signal quality % scaled based on the PLP that requires the most signal-to-nosie to work for that virtual channel.

In older firmware there was a bug in the channel scan...

If the virtual channel information from the low bitrate PLP was received before the PLP mapping information was received the HDHomeRun would report the channels without tuning the audio/video PLP. This caused two quirks:

1) The channel scan would report the signal quality % of the low bitrate PLP, rather than the signal quality % of the audio/video PLP actually needed to watch the channel.

2) When you went to tune the virtual channel the tune would take longer because the HDHomeRun would tune the low birtate PLP first, discover it needed the audio/video PLP, then have to tune again to make things work.

We didn't notice until now because the scan detected channels and the channels played.

wtg
Posts: 257
Joined: Thu Jan 18, 2007 5:21 am
Device ID: Flex 4k
x 3

Re: 20261107 firmware channel scan may report lower signal quality than before (ATSC 3.0 channels only)

Post by wtg »

So if we've applied the firmware upgrade but have not re-scanned channels, should we avoid that for the time being?

nickk
Silicondust
Posts: 21249
Joined: Tue Jan 13, 2004 9:39 am
x 455

Re: 20261107 firmware channel scan may report lower signal quality than before (ATSC 3.0 channels only)

Post by nickk »

wtg wrote: Tue Nov 17, 2026 4:40 am So if we've applied the firmware upgrade but have not re-scanned channels, should we avoid that for the time being?
The new firmware is the correct handling and will make ATSC 3.0 channel changes faster if you were seeing this problem with the old firmware.

Post Reply