Powering HDHomeRun Flex over Power over Ethernet (PoE) splitter?

Reception, channel detection, network issues, CableCARD setup, etc.
Post Reply
joshz
Posts: 1
Joined: Thu Nov 14, 2024 11:10 am

Powering HDHomeRun Flex over Power over Ethernet (PoE) splitter?

Post by joshz »

Does anyone know if it's possible to power a HDHomeRun using a PoE splitter? I'd like to place this closer to the antenna, which doesn't have an AC line near it.

Fin74501
Posts: 35
Joined: Thu Oct 15, 2020 10:49 pm
x 6

Re: Powering HDHomeRun Flex over Power over Ethernet (PoE) splitter?

Post by Fin74501 »

joshz wrote: Thu Nov 14, 2024 11:13 am Does anyone know if it's possible to power a HDHomeRun using a PoE splitter? I'd like to place this closer to the antenna, which doesn't have an AC line near it.
From reddit

"It doesn’t, but you get a box that splits the poe out to a barrel connector of the appropriate voltage/polarity and with enough current and it will power your device. The plus side of this if you already have a poe switch, is you can easily power cycle a box if needed. You also have less ac plug clutter"


https://www.reddit.com/r/hdhomerun/s/A34kxnWZMG

jasonl
Silicondust
Posts: 17149
Joined: Sun Oct 28, 2007 9:23 pm
x 62

Re: Powering HDHomeRun Flex over Power over Ethernet (PoE) splitter?

Post by jasonl »

It is not recommended or supported and may lead to performance issues if the voltage delivered is not stable. Additionally, please note that the HDHomeRun is designed for use in 0-40 °C (32-104 °F) ambient temperatures, and should not be installed outdoors or in a non-climate-controlled attic.

Post Reply