you are right - the open_basedir is likely the issuepoorman wrote: ↑Wed Nov 29, 2017 4:21 pmI have tried these steps and report that it works ... mostly. When on the HDHomerunDVD DSM page I select action run or stop, your software does stop or start the record engine (./hdhomerun_record status). However when I follow the URL, in my case is http://nas/HDHomeRunDVR/, i receive a 500 There is an error while processing this request.
Maybe I have the open_basedir incorrect. I'm unsure of the delimiter between the two entries. I have "/var/packages/HDHomeRunDVR:/volume1/HDHomeRunDVR". Should it be a colon : ? Both paths have been verified.
No worries here though, I know it is in development so I can patiently await the next version and try again.
yes - the delimiter is usually :
but you need to have the existing paths there too - i.e. add these directories to the existing list... not replace the list
If you have removed them - then just make it blank.. this will remove the restriction anyway
for the first one..
I'm not sure if this should be like I have, or /var/packages/HDHomeRunDVR/target or /volumeX/@appstore/HDHomeRunDVR (where X is the volume that /var/packages/HDHomeRunDVR/target points to).
Try one and changes to other if not working.
you need this path to get the DVR version, and check if it's running, as well as modifying the config file.
The second dir /volume1/HDHomeRunDVR needs to be changed to where ever your recordpath is pointing to.
This is only needed for the logfile parsing.