I have a HDHR3-US with the 20170930 firmware. When I scan for channels it doesn't find a specific station in my area that shows up crystal clear on my TV if I change the antenna over to that. The antenna is roof mounted.
I discovered that tuner0 shows only ~35% signal quality but tuner1 shows 86%
I have enabled the "send diagnostic information" setting
Restated the HDHR3
Scanned for channels again
Any ideas what it could be?
Thanks in advance!
Reception, channel detection, network issues, CableCARD setup, etc.
3 posts • Page 1 of 1
- Posts: 8145
- Joined: Wed Jan 24, 2007 1:04 am
- Device ID: 131B34B7 13231F92 1070A18E 1073ED6F
Typically when one tuner starts to fail its a power supply issue.