I have seen this happen on my Shield as well. It's been a while since, though.

Is any progress being made on this issue yet? It took me forever to change channels today from 202 to 351.

I've had this happen often with my Shield, where all I get is a black screen when I stop the app, then restart it in order to load a new UI version. And a new non-early-access release was made earlier today, version 20190911b. Usually when I get a black screen trying to load a new UI version, I forc...

Yes. I have Spectrum/Bright House, and one of my Primes sees 401 channels and the other Prime sees 402. For me, the missing channel is inconsequential as it's not one that I would normally watch.

Thank you.

Bump.

No comment from SD?

Yes.

I understand the cause, but it should NOT jump back and forth like that. They should limit the speed at which it will scroll such that, when holding the up or down button, the jumping doesn't occur.

This is not a new issue with this release as I've reported it before. But now I have a video to show what it's doing since it's difficult to describe. https://1drv.ms/v/s!AmC2D9qWVVZHh27FgU06ROSAAXrj When you hold the up or down button on the remote to move the channel select cursor on the slice to ...

I don't have any of my channels disabled. Also, the slice is still doing that thing where, when you hold the up or down button on the remote to move the channel select cursor on the slice to another channel either much higher or lower in the line-up, it will increment/decrement for a while, but then...

There is still considerable delay (3 to 5 seconds) on my Shield as well, from the time I press the up/down button on the remote to the time the slice slides out so I can change channels. I have Spectrum with 402 channels.

After my post, I again force-stopped/cleared the cache, then let the Shield sit on its home screen for a couple of hours. Then a few minutes ago, I tried starting the app again, and this time it loaded the new UI 0903b. I'll have to remember next time not to try to load a new UI right after I read t...

Same thing on my Shield. Turned off early access, the app restarted to load the new UI (0903b), and then went to a black screen, where it's been sitting for about 10 minutes. Still won't recognize any remote buttons except the home button, which takes me out of the app to the Shield's home screen.

I turned off early access to load UI 0903b, and the app restarts, but leaves me at a black screen where no remote buttons work except the home button which takes me to the Shield's home page. I tried force-stopping/clearing the app cache, but that didn't fix it. So I then rebooted my Shield, but tha...